Removal and installation the lower cover of the central section of the instrument panel — models with automatic transmission (Honda CR-V 2)

This area contains the Supplemental Restraint System (SRS) components. Review the SRS component locations, precautions, and procedures before performing repairs or maintenance.

Note:

• Avoid scratching the instrument panel and adjacent components.
• The picture shows a left-hand drive model; the arrangement on the right-hand drive model is symmetrical.

1. Remove the following components:

• Lower dashboard panel on the passenger side.
• Heater control panel.

2. Open your pocket. Remove screws (A, B) and clips (C) from the lower cover of the instrument panel center section (D).



3. Remove the lower cover of the center section of the instrument panel (A).

• Pull the cover section around the parking brake lever and release the clips (B).
• Pull the cover and release the clamps (C, D).
• Disconnect the cigarette lighter connector (E) and the ashtray lamp socket (F) (on some models).

4. If necessary, remove the pocket (A) from the lower cover of the center section of the instrument panel (B).

• Remove the bolts.
• Remove the stoppers (C) from the cover.
• Remove the hinges (D) from the lid.

5. The cover is installed in the reverse order of removal, taking into account the following:

• Replace damaged clamps.
• Make sure the cigarette lighter connector is securely connected and the ashtray lamp socket is properly connected.