1. Remove both steering column covers.
2. Move the transmission selector to position N.
3. Loosen the nut and remove the cable end from the gear shift rod.
4. Pull the cable towards you until it stops and release. Feed the cable away from you.
5. Turn on the ignition and make sure that the N position lamp lights up.
6. Insert a 6 mm diameter pin into the hole in the retainer plate and pass it through the hole in the bracket.
7. Place the cable on the stud and tighten the cable locknut.
8. Remove the pin.
9. Move the selector to all positions and make sure that the indicator lamps light up in all selector positions.
Shift Rod (6-Cylinder Odyssey) (Honda CR-V 1)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits