Withdrawal
1. Disconnect the battery from the ground.
2. Remove the air duct by disconnecting the hoses.
3. Remove covers of a collector and coils of ignition.
4. Disconnect the throttle and cruise control cables from the throttle body.
5. Disconnect from a collector hoses of the vacuum amplifier and ventilation of a crankcase.
6. Disconnect from a collector sockets of conducting.
7. Disconnect hoses from a throttle branch pipe.
8. Remove manifold and clean.
Installation
9. Install the manifold in place, replacing the gasket. Tighten the manifold mounting bolts in the order shown in the photo with a torque of 22 Nm.
10. Further assembly is carried out in the reverse order.