2. Unscrew the oil filter holder.
3. Screw in the new oil filter holder and tighten to 49 Nm (5.0 kgf·m).
[Refer to the original source on the website www.hondabook.ru]
Replacing the oil filter holder (Honda CR-V 2)
1. Unscrew the oil filter.
2. Unscrew the oil filter holder.
3. Screw in the new oil filter holder and tighten to 49 Nm (5.0 kgf·m).
[Refer to the original source on the website www.hondabook.ru]
2. Unscrew the oil filter holder.
3. Screw in the new oil filter holder and tighten to 49 Nm (5.0 kgf·m).
[Refer to the original source on the website www.hondabook.ru]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Mikhail Kopasov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits