CR-V Models
1. Remove the 2 screws at the top of the instrument panel trim.
2. Remove the trim by pushing its lower part and removing it from the latches.
3. Unscrew the 2 upper and 2 lower instrument panel mounting screws.
4. Lift the shield, disconnect the wires from the back side and remove.
5. Installation is carried out in reverse order.
Odyssey 4-cylinder models
1. Pry up and remove the left ventilation nozzle.
2. Unscrew the 2 upper and 1 left screw and remove the instrument panel trim.
3. Unscrew the 4 instrument panel mounting screws, covering the steering column covers with a clean rag.
4. Pry up the shield and disconnect the connectors.
5. Remove the instrument panel.
6. Installation is carried out in reverse order.
Odyssey 6-cylinder models
1. Remove 4 screws and both steering column covers.
2. Remove the center panel by prying it up and off the latches.
3. Pry up the switch panel on the driver's side, disconnect the connectors and remove the panel.
4. Remove the six screws along the bottom and two screws at the top of the dash panel trim.
5. Carefully push the upper part of the dashboard trim towards you, removing it from the latches, disconnect the connector and remove the trim.
6. Loosen the shield mounting screws, covering the steering column covers with a clean rag.
7. Remove the instrument cluster, disconnect the connector and remove.
8. Installation is carried out in reverse order.
 |
 |
 |
 |
The article was copied from the website: HONDABOOK.ru