Windshield Wiper Motor — Removal and Installation (Honda CR-V 1)

1. Set the wipers to the parked position, turn on the ignition if necessary and turn the wipers on/off.

2. Remove the brushes from the levers.

3. Remove the latch caps from the cover that covers the windshield wiper mechanism.

3. Remove the latch caps from the cover that…

4. Using a pair of thin tools, remove the lower latches of the cover that covers the windshield wiper mechanism.

5. Remove the 2 decorative wiper shaft covers and remove the cover.

6. Unscrew the 4 windshield wiper mounting bolts.

7. Disconnect the connector from the electric motor, remove the electric motor with rods.

8. Mark the orientation of the motor shaft relative to the wiper rod, unscrew the nut and remove the wiper rod with light blows of a screwdriver handle.

9. Unscrew 3 bolts and remove the electric motor.

10. Installation is carried out in reverse order. If the electric motor is changed, it should be cycled so that the shaft takes the parked position. To do this, connect the connector to the electric motor and install the electric motor in place, turn on the ignition and turn on the electric motor, moving the windshield wiper switch to low speed. Turn off the ignition, the electric motor will automatically stop in the position corresponding to the parked position of the brushes.