2. Apply Urea Grease UM264 (41211-PY5-305) onto the splines (A) of the clutch driven disc (B), then install the clutch driven disc using the special tool as shown in the figure.
3. Install the pressure plate (A) and tighten the mounting bolts (B) by hand.
4. Tighten the mounting bolts in a cross pattern. Tighten the bolts in several passes to avoid warping the diaphragm spring.
Tightening torque of the pressure plate: 25 Nm (2.6 kgf·m)
5. Remove the special tool.
6. Make sure the tops of the diaphragm spring are the same height.