Installing the steering wheel (Honda CR-V 2)

1. Before installation, make sure the front wheels are in the straight-ahead position, then center the spiral wire (A) by first turning the spiral wire clockwise until it stops. Then turn it counterclockwise about two and a half turns. The arrow (B) on the spiral wire label must point straight up.



2. Position the two tabs (A) of the turn signal switch bushing (B) as shown in the figure. Place the steering wheel onto the steering gear shaft, making sure that the steering wheel hub (C) fits into the pins (D) of the spiral wire and the tabs of the turn signal switch bushing. When installing the steering wheel, do not hit the steering wheel or steering gear shaft.



3. Insert the bolt (A) into the steering wheel and tighten it to the specified torque. Connect the connectors to the horn switch and the cruise control SET/RESUME switch, Make sure the wiring harness is properly routed and secured.





4. Install the driver's airbag assembly and make sure the system is working properly.

5. Check that the horn and turn signal switch are working properly.