Note:
- Wear protective gloves.
- Be careful not to scratch the back door.
- Do not damage the wires and contacts of the rear window heater.
1. Remove the rear door side trim on both sides.
2. Remove the high brake light.
3. Disconnect the connectors (A) from the rear window defogger and remove the wiring harnesses (B) and harness holders (C) from both rear window support pillar brackets (D). Remove the wiring harness from the trim channel (E) on the right side.
4. After securing the rear door glass with a T30 Torx head, remove the bolts, then remove the rear door glass support pillar brackets (A) on both sides.
5. With the rear door glass (A) secured, remove the bolt using a T30 Torx head, then peel off the double-sided adhesive tape (B), remove the rear door glass support pillar (C), remove the nut (D) from the pillar and remove the seal (E) from the rear door glass.
6. Ask your partner to hold the rear door glass and unscrew the nuts on both sides. Unlock the rear door glass lock.
7. Remove the rear door glass (A). Be careful not to scratch the rear door.
8. Installation of the glass and support pillar is carried out in the reverse order of removal, taking into account the following:
- Replace the mounting bolt of the removed support stand with a new one.
- Make sure the rear window defroster connectors are securely inserted.
- Adjust the position of the glass.
- Make sure the rear door glass opens properly and locks securely.
9. Check for water leakage.
[Full version on the source website www.hondabook.ru]