Note:
- Wear protective gloves.
- To avoid damage, place the rear door glass in a safe place.
- Do not damage the wires and contacts of the rear window heater.
1. Remove the rear door glass.
2. Remove the rear door glass hinges on both sides.
3. Remove the molding (A) from the top edge of the rear door glass (B). Trim the molding with a knife if necessary.
4. Use a spatula to scrape off all traces of old adhesive from the rear door glass. Clean the top edge of the glass with isopropyl alcohol where the new molding will be glued. Make sure there is no water, oil or grease on the contact surface.
5. Apply primer (YOKOHAMA RUBBER MS-90 or equivalent) on the top edge of the rear door glass (A). Do not touch the areas of the rear door glass where the primer will be applied.
6. Apply primer (SAKAI CHEMISTRY SL-8861 or equivalent) along the entire length of the molding groove (A) and apply a bead of urethane adhesive (B) into the molding groove.
7. Align the edge of the molding (A) with the corner edge of the rear door glass (B) and glue the molding.
8. Scrape off or wipe off excess glue with a spatula or napkin. Remove the adhesive from the rear door glass with a soft cloth soaked in alcohol.
9. Allow the glue to dry for at least 1 hour.
10. Install the rear door glass hinges.
11. Install the rear door glass.
The original is located on the website: HONDABOOK.ru