Rear door glass.
1 - upper glass seal,
2 - upper stopper,
3 - lower stopper,
4 - rear door glass,
5 - lower glass seal.
1. Remove the rear door interior trim (see section "Back door").
2. (Some models are left-hand drive) Remove the rear door spoiler.
3. Remove the additional brake light bulb (see chapter "Body electrical equipment").
4. Remove the rear door glass wiper arm and blade (see chapter "Body electrical equipment").
5. Remove the rear door glass washer hose (see chapter "Body electrical equipment").
6. Remove the upper and lower (A) rear door glass seal.
7. Disconnect the rear door glass heating connectors (A).
8. From the inside of the body, using an awl, make holes in the layer of glue (B). From the interior, pull the string (A) through the holes.
Note: To avoid damaging painted surfaces, apply masking tape to them.
Caution: To avoid damaging your hands on sharp edges, wear gloves.
9. Secure the ends of the string to the wooden blocks.
Note: To avoid breaking the string, use its entire length while working.
10. Cut off the layer of glue (A) along the entire perimeter of the glass (B).
11. Carefully remove the rear door glass.