1. Remove the used liquid with a bulb and rinse the tank.
2. Attach the bleed hose to the cylinder nipple.
3. Fill the reservoir with fresh fluid and fill the reservoir halfway with fresh DOT 3 or DOT 4 brake fluid
4. Unscrew the nipple and ask an assistant to press the clutch pedal.
5. Tighten the nipple and ask the assistant to slowly release the clutch pedal.
6. Repeat the procedure until no more air bubbles come out of the hose at the fitting. Maintain the fluid level in the reservoir.
Bleeding the Clutch Hydraulic Drive (Honda CR-V 1)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits