2. Disconnect the cardan shaft from the gearbox.
3. Install the jack cart over the gearbox and remove the left and right brackets.
4. Disconnect the breather hose from the fitting on the rear suspension cross member.
5. Carefully pry and feed the axle shaft out of the gearbox until the axle shaft circlip comes out of the groove.
6. Turn away the top bolts of an arm of a reducer.
7. Lower the gear like this. so that you can get the axle shafts, remove the gearbox.
8. Remove bracket from gearbox.
9. Installation is carried out in the reverse order. When assembling, replace the axle shaft circlips and all oil seals. Install the cardan shaft according to the marks made during disassembly. Tighten fasteners to specified torques.
Rear gear and tightening torques: 1. Reducer bracket; 2. Rear gear