1. Disable the pneumatic safety system (Chapter 6).
2. Remove the lower instrument panel cover and knee pad.
3. Remove the steering column covers.
4. Disconnect the wiring from the fuse box.
5. Remove the upper and lower steering column covers.
6. Set the switch to position "0".
7. Loosen the mounting screws.
8. Remove the contact part of the ignition switch.
9. Installation is carried out in reverse order.
Contact part of the ignition switch — removal and installation (Honda CR-V 1)
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits