CR-V and 4-cylinder Odyssey
1. Remove the inner door panel and plastic screen.
2. On 4-cylinder Odyssey rear doors, remove the bolt and rear window track.
3. Raise the glass to provide access to the bolts.
4. On 4-cylinder Odyssey rear doors, remove the screws and window corner, remove the mounting bolts and carefully lower the glass, then remove the lower gutter bolt and nut. Remove the glass from the rear guide, tilt the glass forward in the direction of the vehicle and remove it through the groove. Loosen the bolts, move the lower channel forward and remove the glass.
5. Remove the glass through the groove.
6. To remove the window regulator, mark the position of the adjusting bolt, disconnect the connector and unscrew the bolts.
7. Installation is carried out in reverse order. Install the window regulator roller so that the rectangular hole faces the rear.
6-cylinder Odyssey
1. Remove the inner door panel.
2. Remove the fasteners and take off the case bracket.
3. Raise the glass so that the mounting bolts are accessible
4. Unscrew the bolts and remove the glass.
5. Installation is carried out in reverse order.
 |
 |
 |
 |
 |
 |
(The original can be found on the resource: hondabook)