Note: Wear protective gloves when removing and installing the glass and window regulator.
1. Remove:
- Door panel (see above)
- Plastic lid
2. Carefully lift the glass until you see the bolts. Loosen them. Slide the guide back, then remove the glass from the guide and carefully lower it. Do not drop the glass inside the door.
3. Disconnect the connector and remove the harness clamp from the door. Mark the original location of the roller guide bolt by running a scriber around it. Loosen and remove the bolts, then remove the window regulator through the hole in the door.
4. Mark the location of the window regulator and drive gear.
5. Remove the bolts, then separate the power window motor and the window regulator. Apply grease to the moving parts of the window regulator indicated by the arrows.
6. Installation is carried out in the reverse order of removal, taking into account the following:
- Move the glass up and down and make sure it moves without sticking.
- Make sure that there is no gap between the glass and the guide channel when closed.
(The original is located on the website HondaBook)