Spring and damper — Accord 1984-85 Removal and installation WARNING: The use of special tools or their equivalent will be required. A spring puller must be used to remove the spring from the strut. 1. Block the front wheels firmly. Raise and secure the...
Spring and damper — Accord 1986-91 1. Remove the top cover and top strut lock nuts. 2. Block the front wheels securely. 3. Raise and secure the rear of the vehicle. 4. Remove the rear wheel. 5. Remove the strut mounting bolt, lower the suspension and...
Spring and damper — Prelude 1984-87 1. Block the front wheels securely. 2. Raise and secure the rear of the vehicle. 3. Remove the rear wheel. 4. Remove the clip holding the rear brake hose. 5. Remove the stabilizer from the lower arm. 6. Loosen the lower...
Spring and damper — Prelude 1988-91 1. Block the front wheels securely. 2. Raise and secure the rear of the vehicle. 3. Remove the rear wheel. 4. Remove the clip holding the rear brake hose. 5. Raise the carpet at the rear of the trunk, then remove the...
Suspension arms — removal and installation Trailer arm Accord 1. Raise and secure the vehicle. 2. Remove the rear wheel. 3. Support the lower suspension arm using a jack, 4. Remove the bolt from the trailing arm bushing. 5. Remove the mounting nuts from the...
Rear wheel bearing — Accord 1984-85 1. Slightly loosen the rear wheel nuts. Raise the car and secure it on jacks. 2. Release the parking brake. Remove rear wheels. 3. Remove the rear bearing hub cap, cotter pin and its holder. 4. Remove the spindle nut,...
Rear Wheel Bearing — Accord 1986-91 Do not tighten or loosen the spindle nut unless the vehicle is on all 4 wheels. The tightening torque is high enough that even a properly secured vehicle can tip over. 1. Loosen the rear wheel and spindle nuts. Raise...
Rear wheel bearing — Prelude WARNING: The use of special tools or their equivalent will be required. To disassemble the hub and bearing, you will need a hydraulic press and a punch and stand of the appropriate diameter. 1. Slightly loosen the rear...
Rear wheel bearing — adjustment 1. Apply lubricant to the spindle nut and spindle thread. 2. Install and tighten the spindle nut to 24 Nm. Rotate the drum/disc by hand 23 turns, then retighten the spindle nut to 24 Nm. 3. Repeat step 2 until the...