Car clutch and drive shafts Honda Accord 6

Clutch and Drive Shaft Specifications
Clutch type Dry single disc, with diaphragm pressure spring Pedal height when disengaging the clutch, mm 76÷89 Free travel of clutch pedal, mm 9.5÷16 Standard clutch pedal height, mm 190.5 Clutch pedal travel, mm 146...

Clutch — General information and component condition check
All models equipped with a manual transmission use a single-plate dry clutch with a diaphragm spring. The hub of the friction (driven) disk is equipped with longitudinal splines that engage with the splines of the...

Removal and installation the clutch master cylinder
Removal 1. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination to activate the audio system before disconnecting...

Removal and installation the clutch slave cylinder
Removal 1. Disconnect the negative cable from the battery. Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination to activate the audio system before disconnecting...

Bleeding air from the hydraulic circuit of the clutch release drive
1. Bleeding of the hydraulic drive of the system release should be carried out each time after removal of its components, and also when the fluid level in the reservoir drops so much that air gets into the master...

Removal, condition check and installation of clutch assembly components
Warning! Remember that dust generated during wear of the clutch slave disk friction linings may contain asbestos, which is harmful to health. Do not blow off dust with compressed air and try not to inhale it. Do not use...

Removal, checking and installation the release bearing and clutch release fork
Warning! Remember that dust generated during wear of the clutch slave disk friction linings may contain asbestos, which is harmful to health. Do not blow off dust with compressed air and try not to inhale it. Do not use...

Adjusting the clutch pedal
Pedal height The height of the pedal position is the distance from its pad to the floor panel. If the measurement result of this distance is outside the permissible range, it is necessary to make the appropriate...

Checking the condition, replacing and adjusting the starter circuit breaker switch sensor
Examination 1. The starter circuit breaker switch is located near the upper end of the clutch pedal. Two wires are connected to the switch, one from the starter relay, the second is ground. When the ignition key is...

Removal and installation drive shafts
Removal 1. Remove the wheel hub cap. If the hub nut is countersunk, bend the locking tab using a center punch or chisel. Note: On some models, the wheel cap is secured with wheel nuts. In this case, the nuts should be...

Removal and installation the intermediate shaft
Removal 1. Loosen the left front wheel mounting nuts. Jack up the front of the car and place it on supports. Remove the wheel. 2. Drain the transmission oil (see Chapter Settings and ongoing maintenance ). 3. Remove the...

Replacing protective covers and checking the condition of CV joints
Note. If defects in the protective cover are detected, the condition of the corresponding CV joint should be carefully examined. Often, fully restored drive shaft assemblies can be purchased on an exchange basis, which...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code