Attention:
- Make sure that brake fluid does not come into contact with paintwork. If the fluid does come into contact with paintwork, wash it off immediately with water.
- To prevent brake fluid from leaking, install plugs on the disconnected pipes.
- Be careful not to allow dust or foreign particles to come into contact with the removed components.
- Do not reuse drained brake fluid.
1. Loosen the connecting bolt and disconnect the brake hose from the caliper body.
2. Hold the hexagonal section of the pin with a wrench, loosen the flange bolts (8 mm) and remove the brake caliper housing.
3. Remove the finger dust boots from the caliper grooves, remove the fingers and remove the finger dust boots.
4. Remove the brake pad spring from the caliper body.
5. Insert a wooden block or cloth into the caliper body, apply compressed air into the hole for the brake hose and push out the piston.
Caution: The piston may come out with great force, so keep your hands away.
6. Remove the piston dust boot and seal.
Caution: Do not scratch the inner surface of the cylinder.
(The text of the article is available on the website «HondaBook.ru»)