Car engine management system Honda Avancier 1
Preliminary remarks on the fuel injection control and emission control system
1. PGM-FI fault diagnosis First, check that the PGM-FI indicator light on the instrument cluster comes on. Before disconnecting and connecting the control unit connectors, be sure to turn the ignition key to the OFF...
1. PGM-FI fault diagnosis First, check that the PGM-FI indicator light on the instrument cluster comes on. Before disconnecting and connecting the control unit connectors, be sure to turn the ignition key to the OFF...
Vacuum tubes and hoses
1. Oxygen sensor 2. Intake manifold pressure sensor 3. Crankshaft sensor 4. TDC sensor 5. Coolant temperature sensor 6. Intake air temperature sensor 7. Knock sensor 8. RACV (RAC air swirl control valve) 9. Fuel...
1. Oxygen sensor 2. Intake manifold pressure sensor 3. Crankshaft sensor 4. TDC sensor 5. Coolant temperature sensor 6. Intake air temperature sensor 7. Knock sensor 8. RACV (RAC air swirl control valve) 9. Fuel...
Diagnostics of engine management system faults
Troubleshooting Sequence When the PGM-FI warning light comes on or you want to diagnose the malfunction of various components, start the diagnosis after checking the PGM-FI warning light, then clear the DTCs (Diagnostic...
Troubleshooting Sequence When the PGM-FI warning light comes on or you want to diagnose the malfunction of various components, start the diagnosis after checking the PGM-FI warning light, then clear the DTCs (Diagnostic...
Checking idle speed on a cold engine
1. If using a tachometer: Remove the rubber cover from the engine speed sensor connector located 1 on the right side of the engine and connect the tachometer. If using the Honda PGM tester or an external diagnostic...
1. If using a tachometer: Remove the rubber cover from the engine speed sensor connector located 1 on the right side of the engine and connect the tachometer. If using the Honda PGM tester or an external diagnostic...
Checking idle speed.
Start the engine and warm it up until the radiator fan runs twice. Then warm it up for more than 2 minutes without load at 3000 rpm. Check the condition of the air cleaner filter element, ignition timing, condition of...
Start the engine and warm it up until the radiator fan runs twice. Then warm it up for more than 2 minutes without load at 3000 rpm. Check the condition of the air cleaner filter element, ignition timing, condition of...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits