Caution: If new pads are installed, adjust the parking brake lever stroke and then bed in the friction linings.
1. Remove the rear brake caliper and remove the brake drum/disc (see chapter Front and rear suspension).
2. Remove 2 springs A from the anchor pins.
3. Press the shoe holder springs, turn the shoe holder and remove the spring.
4. Remove the lever spring and remove the connecting lever.
5. Slide the pads down and remove spring B and the regulator.
6. Disconnect the parking brake cable from the operating lever.
7. Remove the U-clamp and remove the wave washer and lever axle from the shoe.
