2. Remove the clamp (A) and unscrew the 1AT(B) sensor.
3. Installation is performed in the reverse order of removal.
Original article on the website: Hondabook.ru
PGM-FI System — IAT Sensor Replacement (Honda CR-V 2)
1. Disconnect the 2-pin connector from the IAT sensor.
2. Remove the clamp (A) and unscrew the 1AT(B) sensor.
3. Installation is performed in the reverse order of removal.
Original article on the website: Hondabook.ru
2. Remove the clamp (A) and unscrew the 1AT(B) sensor.
3. Installation is performed in the reverse order of removal.
Original article on the website: Hondabook.ru
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Mikhail Kopasov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits