2. Disconnect the connectors from the fuel injectors (A), ground cable (B).
3. Disconnect the quick-release fittings (C)
4. Remove the mounting nuts (D) from the fuel distribution line (E).
5. Remove the clamp (F) from the fuel injector.
6. Remove the fuel injectors from the fuel distribution line.
7. Apply clean engine oil to new O-rings (A) and screw the fuel injectors (B) into the fuel rail (C).
8. Install the clamp (D) onto the fuel injector.
9. Apply clean engine oil to the fuel injector O-ring (E).
10. To avoid damaging the O-rings, first screw the fuel injectors into the fuel rail and then place them into the injector base (F).
11. Install and tighten the mounting nuts on the fuel distribution line and connect the ground cable.
12. Connect the connectors to the fuel injectors.
13. Connect the quick-release fittings.
14. Turn the ignition key to the ON (II) position, but do not operate the starter. After the fuel pump has been running for approximately 2 seconds, pressure will build up in the fuel line. Repeat this operation two or three times, then check for fuel leaks.
Based on materials from the website hondabook.ru