2. Disconnect the 2-pin connector from the ECT sensor.
3. Unscrew the ECT sensor (A).
4. Install the sensor in the reverse order of removal, installing a new O-ring (B).
Original published on this resource: HONDABOOK
PGM-FI System — ECT Sensor Replacement (Honda CR-V 2)
1. Remove the air cleaner.
2. Disconnect the 2-pin connector from the ECT sensor.
3. Unscrew the ECT sensor (A).
4. Install the sensor in the reverse order of removal, installing a new O-ring (B).
Original published on this resource: HONDABOOK
2. Disconnect the 2-pin connector from the ECT sensor.
3. Unscrew the ECT sensor (A).
4. Install the sensor in the reverse order of removal, installing a new O-ring (B).
Original published on this resource: HONDABOOK
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Mikhail Kopasov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits