Replacing the rear side door center pillar seal (Honda CR-V 2)

Note: Do not scratch the door.

1. Pull the door center pillar seal (A) and remove it.

2. After placing the seal on the top edge of the door opening, align the seal with the bottom edge of the door opening, then place the seal along the entire length.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Mikhail Kopasov

◀ Previous

CR-V 2: Doors, locks and windows

Next ▶

Replacing the rear side door seal
Replacing the outer seal of the rear side door glass
Replacing the glass and window regulator of the rear side door
Replacing the rear side door lock
Replacing the outer handle of the rear side door

Replacing the waterproof film in the rear side door guides
Adjusting the position of the front and rear side door glass
Adjusting the position of the front and rear side door
Adjusting the position of the front and rear side door latch hinge
Rear view mirrors

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet