Power Steering Pump — Replacement (Honda HR-V 1)

1. Place a suitable container under the vehicle.

2. Drain the power steering fluid from the reservoir.

3. Remove the belt by loosening the pump mounting bolt and lock bolt.

4. Cover the air conditioning compressor with several napkins to prevent spilled liquid from getting on it. Disconnect the supply hose and supply tube from the pump and plug them. Do not spill liquid on the body or adjacent parts. Wipe up any spilled liquid immediately.



5. Loosen the pump mounting bolts and the lock bolt, then remove the pump. After removing the pump, do not turn the steering wheel.

6. To prevent foreign particles from entering the pump, cover the hole in the pump with a piece of adhesive tape.

7. Connect the feed hose and feed tube to the pump. Tighten the pump fittings securely.

8. Install the pump on the bracket by tightening the mounting bolt and lock bolt.

9. Install the pump drive belt.

When putting on the belt, please consider the following:

• Make sure the power steering pump drive belt is properly positioned on the pulleys.
• Do not allow any liquid or grease to come into contact with the belt or pulley surfaces. Remove any liquid or grease before installing.

10. Adjust the pump drive belt (see above).

11. Fill the tank to the upper level mark (see above).

The original is located on the website: HondaBook.ru