Precautions during repairs This 4WD model does not have a mechanical switch between 4WD and 2WD (front wheel drive). Therefore, checking the speedometer should be carried out on the rollers under the rear wheels. Precautions when using rollers:...
Rear differential — design description Key points On models with Real-Time 4WD-Dual Pump System (4 wheel drive with two pumps) the rear differential has a hydraulic clutch and a differential mechanism. Under normal conditions, the vehicle is driven from the...
Troubleshooting the AWD System When pulling away and accelerating in forward gears (4WD mode) Manual Transmission (ITUC): 1. Raise the car with all four wheels ( see ch. 1 ). 2. Start the engine and warm it up to normal operating temperature (the...
Troubleshooting Rear Differential Diagnosis of most malfunctions in the mechanism is carried out by analyzing the noise in the gears or bearings. When diagnosing, do not confuse noises in the differential with noises in other components of the chassis.
Rear differential maintenance Warning! Make sure the lifts are properly installed ( see ch. 1 ). 1. Stop the vehicle on level ground and check the differential fluid with the engine off. 2. Unscrew the filler plug, then check the level and condition...
Removing the rear differential 1. Raise the front of the vehicle and secure it to the safety stands at the correct points ( see ch. 1 ). 2. Drain the oil from the rear differential ( see above ). 3. Mark the driveshaft and rear differential flanges....
Fixing a rear differential leak 1. Turn off bolts crosswise, then remove a case of differential. 1. 8x1.25 mm, 22 Nm (2.2 kgf/m) 2. DIFFERENTIAL CASE 3. SEALS. Replace 2. Apply sealant to the sealing surface of the differential case, taking into...
Replacing the rear differential seals 1. Remove the oil seals from the differential housing. 2. Using the special tool, press in the oil seals without distortion. Do not damage the lip of the seals. 3. Take out an epiploon from a case of...
Rear differential assembly 1. Apply CVT fluid to the oil filter rubber, then install the oil filter, magnet and oil pump pin to the differential cup. 2. Align the oil pump pin with the groove on the rear oil pump in the pump housing assembly,...
Installing the rear differential Note: When installing the rear differential and mount assemblies, first tighten the mounting bolts (A) supports B of the rear differential, then the fixing bolts (IN) rubber support A of the rear differential. 1....