Note: The headlight and turn signal switch works regardless of the position of the key in the ignition switch.
A) Turning the switch knob to the first click (position "ON1") turn on the dimensions of the illumination of the instrument cluster and license plate.
b) Turning the switch knob to the second click (position "ON2") headlights turn on.
Attention: To avoid discharging the battery, do not leave the headlights on for a long period of time when the engine is off.
2. To turn on the high beam headlights, push the switch away from you. The operation of high beam headlights is accompanied by the illumination of the corresponding indicator on the instrument cluster.
To turn off the high beam headlights and turn on the low beam headlights, move the switch to its original position.
3. For short-term switching on high beam headlights (high beam alarm) Pull the switch towards you as far as it will go, then release.
4. Move the switch up or down to turn on the turn signal. The switch will automatically return to its original position after the turn is completed. However, when changing lanes, you may need to return the switch to neutral by hand.
To turn on the lane change signal, move the switch up or down until there is resistance to movement and set it in this position.
6. Alarm, activated by pressing the switch, located as shown in the figure.