Contents: Removal ⇊ Installation ⇊
Note:
- Do not spill brake fluid on your car as it may damage the paintwork; if liquid does spill, wash it off immediately with water.
- When removing and installing, do not damage or deform the brake pipes.
- To prevent brake fluid from leaking, plug and seal the ends of the hoses and fittings with napkins or similar material.
Removal
1. Turn the ignition key to the OFF position.
2. Disconnect the cable from the negative battery terminal.
3. Pull the lock (A) of the 47-pin ABS control unit connector (B), then disconnect the connector.
4. Disconnect the six brake pipes.
5. Remove the ABS modulator-control unit (C)/bracket (D) from the body.
6. Remove the two 6mm flange bolts and the 6mm bolt from the bracket, then remove the ABS modulator-control unit from the bracket.
Installation
1. Install the ABS modulator-control unit to the bracket, then tighten the two 6mm flange bolts and the 6mm bolt.
2. Install the ABS modulator-control unit/bracket on the body.
3. Align the contact surface of the ABS control unit and the 47-pin connector.
4. Press the lock of the 47-pin ABS control unit connector, then connect the connector.
5. Connect the six brake pipes.
6. Bleed the brake system, starting with the front wheels.
7. Start the engine and make sure that the ABS indicator and brake system indicator go out.
8. Conduct a road test and make sure the ABS indicator and brake system indicator do not come on.
(The original is located on the website: hondabook)