Procedure for removing the jack
Loosen the jack stand and remove it.
Note: When installing the jack in place, do not push it with great force, as this may damage the seat.
Jack installation locations
Installing the jack
1. The car must be on a level and solid surface.
2. Apply the parking brake firmly and block the wheel on the other side of the puncture diagonally, in front and behind, using, for example, stones.
3. Place the jack on the ground, manually rotate the jack until the groove enters the installation place.
4. Using the handle and adapter, lift the car so that the wheel is slightly raised from the ground.
Warning! A car raised by a jack is in an unstable position, so it is dangerous to be under the car at this moment.
Attention! For safe use of the jack it is necessary:
- Turn off the engine.
- The ground surface must be firm and level.
- Do not lift a loaded vehicle.
- There should be no objects above or below the jack.
- Do not use the jack except when changing wheels or installing snow chains.
Note: Use only the jack that comes with your vehicle. Other jacks may have different lifting capacity or shape.