First steps
1. Stop the vehicle on a level, safe place and remove the tools and spare tire.
2. Securely tighten the parking brake. The wheel located diagonally to the punctured one is blocked at the front and back using, for example, stones.
3. Place the spare tire under the vehicle next to the punctured tire with the disc facing up.
Raise the car with a jack
1. Install the jack (see above).
2. Using a wrench, loosen the wheel nuts (turn about one turn).
3. Raise the car with a jack so that there is a small gap between the ground and the wheel.
Wheel replacement
1. Unscrew the nuts, cap, then remove the wheel.
Note: Place the removed wheel face up.
2. Wipe the contact surfaces on the hub and wheel disc.
3. Install the spare tire.
4. Lightly tighten the nuts so that they fit into the recesses of the disc and the wheel does not wobble.
5. Lower the jack and finally tighten the nuts (nut tightening force - 10-12 kg·m), going sequentially 2-3 times in the sequence shown in the figure.
Laying a standard wheel
1. Standard wheel with aluminum disk.
Remove the center cap from the punctured standard tire.
2. The punctured standard wheel is turned face down and secured with a mounting screw.
Note: When installing a standard wheel, it is not possible to install the trunk lid in its original position, so it must be placed on top of the standard wheel.
Article source on the website HondaBook