1. Disconnect the battery from the ground.
2. Open the hood.
3. Remove the grille and front bumper.
4. Remove the fender guard trim by removing the 2 latches (to do this, remove your finger and remove the latch sleeve) and loosen the screws.
5. Disconnect headlight sockets, turn away bolts and remove headlights.
6. Mark the position of the wing on the body, outline the contour of the wing on the protective panel of the wheel well with a thin hard pencil.
7. Open the doors and remove the rear bolts on the protective panel of the wheel arch.
8. Turn away bolts of fastening of a wing on the top cross partition of salon, on apertures of headlights and along a wing in a motor compartment.
9. With an assistant, remove the wing.
10. Installation is carried out in the reverse order.