Contents: Checking the level ⇊ Replacement ⇊
Checking the level
1. Place the vehicle on a flat, horizontal surface.
2. Replace the filler plug (A) and remove the gasket (B).
3. Make sure that the oil level in the crankcase is below the filler plug hole. If necessary, add oil to the crankcase.
- Oil - DPSF
4. Install a new gasket and tighten the filler plug.
- Tightening torque - 47 Nm
Replacement
1. Place the vehicle on a flat, horizontal surface.
2. Unscrew the filler plug and remove the gasket.
3. Unscrew the drain plug (C), remove the gasket (B) and drain the oil from the rear gearbox.
4. Install a new gasket on the drain plug and tighten the drain plug.
- Tightening torque - 47 Nm
5. Fill the rear gearbox with oil.
- Oil - DPSF
Filling capacity:
- in a "dry" gearbox - 1.2 l
- when replacing - 1.0 l
6. Make sure that the oil level in the rear gearbox is at the lower edge of the filler hole.
If necessary, top up the oil level to the specified level.
7. Install a new gasket on the filler plug and tighten the filler plug.
- Tightening torque - 47 Nm