Disassembly
1. Remove the cylindrical pin at the end of the shaft.
2. Remove the bushing.
3. Remove the washer.
4. Remove the gasket.
5. Remove the spring.
6. Remove the selector lever.
Inspection
1. Inspect the spring, gasket and washer for deformation and rust.
2. Inspect the hole in the center of the holder for wear.
3. Inspect the selector lever for wear or bending.
4. Inspect the roll pin hole for stretching.
Assembly
1. Install the selector lever onto the axle on the holder.
2. Install the spring, paying attention to the correct position of its ends.
3. Install the correct sized gasket if replacing.
4. Install the washer.
5. Install the bushing and cylindrical pin.
(The original text of the article is located on the website www.hondabook.ru)