Warning!
- Do not spill brake fluid on your vehicle; it can ruin the paint; if brake fluid gets on the paint, wash it off immediately with water.
- Clean all components in brake fluid and air dry; blow out all channels with compressed air.
- Before assembly, wipe off dust and remove foreign particles from all components.
- Replace components if directed.
- Prevent dirt and other foreign substances from entering the brake fluid.
- Do not mix brake fluid of different brands, as they may be incompatible.
- Do not reuse drained brake fluid. Use only Genuine Honda Brake Fluid or equivalent DOT3 or DOT4 fluid (pictured below).
HONDA Genuine Urea Grease UM264 (P/N41211-PY5-305).
Brake grease or equivalent rubber lubricant.
1. LUBRICATION (for brakes)
2. WORKING CYLINDER SPRING. Install with the small end facing the piston
3. WORKING CYLINDER BODY. Check the cylinder walls for scratches and wear
4. BLEEDER PIPE. 7.8 Nm (0.8 kgf/m)
5. BLEEDER CAP
6. BOOT. Make sure it is securely fastened to the cylinder body
7. PUSH ROD
8. WORKING CYLINDER PISTON. Check for wear and damage
9. PISTON CUFF A. Replace
10. PISTON CUFF B. Replace
11. UREA GREASE UM264 (P/N41211-PY5-305)
12. LUBRICATION (for brakes)
[Full version on the source website hondabook.ru]