Note:
- When removing the gearbox, clean and lubricate the sliding surface of the release bearing.
- When removing components marked with an asterisk (*), the hydraulic clutch system must be bled (see below).
- Check hoses for damage, leaks, obstructions and kinks.
- The picture shows a left-hand drive model; the arrangement on the right-hand drive model is symmetrical.
1. Cotter Pin, Replace.
2. PEDAL PIN
3. CLUTCH PIPE, 19 Nm (1.9 kgf/m)
4. TANK
5. 6x1.0 mm, 9.8 Nm (1.0 kgf/m)
6. TANK HOSE
7. CLUTCH MASTER CYLINDER
8. CLUTCH TUBE, 15Nm (1.5 kgf/m)
9. 12x1.0 mm, 103 Nm (10.5 kgf/m)
10. FLYWHEEL
11. PRESSURE DISC
12. 8x1.25 mm, 25 Nm (2.6 kgf/m)
13. CLUTCH SLAVE CYLINDER
14. 8x1.25 mm, 22 Nm (2.2 kgf/m)
15. CLUTCH PIPE, 15 Nm (1.5 kgf/m)
16. GEARBOX
17. RELEASE BEARING
18. CLUTCH DRIVE DISC
19. CLUTCH HOSE
20. 6x1.0 mm, 9.8 Nm (1.0 kgf/m)
21. CLUTCH PIPE, 24 Nm (2.4 kgf/m)
22. 8x1.25 mm, 13 Nm (1.3 kgf/m)
23. CLUTCH PEDAL