Flywheel and drive disk — replacement (Honda HR-V 1)

Contents: Manual transmission (MT) ⇊ Automatic transmission (AT) ⇊

Manual transmission (MT)

Remove the six flywheel bolts, then separate the flywheel from the crankshaft flange. After installation, tighten the bolts in a cross pattern.

1. GEAR HOLDER, 07LAB-PV00100
2. CYLINDER BLOCK
3. 12x1.0 mm, 118 Nm (12.0 kgf/m)
4. GEAR HOLDER, 07LAB-PV00100
5. CROWN GEAR. Check the crown teeth for wear or damage.

Automatic transmission (AT)

Remove the six drive plate bolts, then separate the drive plate from the crankshaft flange. After installation, tighten the bolts in a cross pattern.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Engine repair

Next ▶

Cylinder block and piston group
Cylinder head — installation
Camshaft, rocker arms, oil seal and camshaft pulley
Valves, Springs and Seats — Installation
Valve guides — replacement

Piston and connecting rod — design description
Connecting rod and crankshaft — axial play
Main bearings — clearance
Main bearings — selection
Connecting rod bearings — clearance

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet