Replacement
Note: Installation is carried out in the reverse order of removal.
1. Remove the air filter housing (see chapter "Maintenance and general check and adjustment procedures").
2. Disconnect the cable from the negative terminal of the battery.
Note: Before disconnecting the wire from the battery, make sure you know the access code for the radio. Otherwise, the radio will be blocked.
3. Remove the battery, battery tray and battery bracket.
4. Loosen the bolt and remove the bracket (A) securing the automatic transmission fluid filter. Place the automatic transmission fluid filter (B) to the side.
- Tightening torque - 12 Nm
2. Disconnect the connector from the second gear clutch fluid pressure sensor.
3. Remove the solenoid valve (A) and O-ring (B) from the solenoid valve.
- Tightening torque - 20 Nm
Note: When installing the solenoid valve, install a new O-ring on the solenoid valve.