Torque Converter Drive Plate (Honda Fit 1)

Removal and installation

1. Remove the gearbox (see section "Removal and installation the gearbox").

2. Loosen the bolts and remove the torque converter drive plate (A) and spacer (B):

Tightening torque - 74 Nm

Note:

Installation is carried out in the reverse order of removal.

Tighten the plate mounting bolts in several passes.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Varvara Vereshchagina

◀ Previous

Fit 1: Automatic gearbox

Next ▶

Working fluid temperature sensor
Third gear clutch fluid pressure sensor
Second gear clutch circuit working fluid pressure sensor
Output shaft speed sensor
Input shaft speed sensor

Selector — removal and installation
Selector device
Gearbox control cable — adjustment
Gearbox Control Cable — Replacement
Removal and installation the gearbox

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet