Replacement
1. Disconnect the cable from the negative terminal of the battery.
Note: Before disconnecting the wire from the battery, make sure you know the access code for the radio. Otherwise, the radio will be blocked.
2. Remove the air filter housing (see chapter "Maintenance and general check and adjustment procedures").
2. Disconnect the connector (A) of the transmission output shaft speed sensor.
3. Loosen the bolts and remove the sensor (B) and O-ring (C).
- Tightening torque: - 12 Nm
Note:
- Installation is carried out in the reverse order of removal.
- When installing, use only a new O-ring.