Selector position sensor (Honda Fit 1)

Examination

1. Remove the center console (see picture) "Body").

2. Disconnect the connector shown in the figure.

3. Set the selector to the "P" position and make sure there is conductivity between the terminals. Move the selector from the "P" position and make sure there is no conductivity between these terminals.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Varvara Vereshchagina

◀ Previous

Fit 1: Automatic gearbox

Next ▶

Selector Lock Solenoid Valve
Replacing the working fluid filter
Checking the level and replacing the working fluid of the automatic transmission
Road test
Pressure check

Start inhibit switch
Shift solenoid valves
Pressure control solenoid valves
Input shaft speed sensor
Output shaft speed sensor

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet