Contents: Removal ⇊ To install: ⇊
Removal
1. Disconnect the air intake pipe from the throttle body.
2. Drain the coolant to at least the level below the throttle body.
3. Disconnect the cooling hoses leading to the throttle body.
4. Label and disconnect the vacuum hoses from the throttle body.
5. Disconnect the electrical connector(s) from the throttle body.
6. Tag and disconnect the throttle control cable and/or accelerator cable.
7. Remove the nuts securing the throttle body to the intake chamber. Loosen each nut 1-2 turns at a time to relieve pressure evenly.
8. Remove the throttle body assembly. Remove the gasket.
To install:
9. Install a new gasket on the intake chamber; install the throttle body onto the struts. Note that the gasket is usually not symmetrical, but has either a mark or a rounded corner; there is only one correct position for her.
10. Install the fastening nuts. Tighten them evenly and alternately to 22 Nm.
11. Install the throttle control cable and/or accelerator cable.
12. Connect the vacuum hoses.
13. Connect the cooling hoses.
14. Fill the cooling system.
15. Connect the air ducts.
