Replacing the outer bearing ring of the transfer case cover A (Honda HR-V 1)

Note: Apply oil to all parts when assembling.

1. Press out the outer race of the tapered roller bearing from the transfer case cover A by heating the cover to almost 100°C using a fan heater. Do not heat the cover to a temperature higher than 100°C.

1. FAN HEATER
2. COVER A OF THE TRANSFER CASE
3. OUTER RING OF THE BEARING

2. Install the 68mm thrust shim into transfer case cover A.

3. Using a special tool, press in the outer ring of the tapered roller bearing.

1. PRESS
2. MANDREL HANDLE, 07749-0010000
3. THRUST GASKET, 68 mm
4. OUTER RING OF THE BEARING
5. MARKET, 62x68 mm, 07746-0010500
6. TRANSFER CASE COVER A

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Mechanical gearbox

Next ▶

Disassembly and assembly of the transfer case shaft
Replacing the Transfer Case Driven Gear Bearing
Replacing the transfer case drive gear bearing
Transfer case — disassembly
Transfer case — checking the elements

Replacing the outer ring of the transfer case bearing
Transfer case — assembly
Front Bearing and Seal — Replacement
Intermediate shaft bearing — replacement
Secondary shaft thrust clearance — adjustment