Disassembly and assembly of the transfer case shaft (Honda HR-V 1)

1. Install the transfer case driven gear on steel blocks, then press the transfer case shaft out of the damper hub as shown in the figure.

1. DAMPER HUB
2. PRESS
3. TRANSFER CASE SHAFT
4. TRANSFER CASE DRIVE GEAR

2. Align the grooves of the damper hub and the teeth of the transfer case driven gear and assemble the damper hub, needle bearing and transfer case driven gear.

3. Press in the transfer case shaft as shown in the figure.

1. PRESS
2. TRANSFER CASE SHAFT

Full version on the source website: HondaBook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Mechanical gearbox

Next ▶

Replacing the Transfer Case Driven Gear Bearing
Replacing the transfer case drive gear bearing
Transfer case — disassembly
Transfer case — checking the elements
Transfer case — design description

Replacing the outer bearing ring of the transfer case cover A
Replacing the outer ring of the transfer case bearing
Transfer case — assembly
Front Bearing and Seal — Replacement
Intermediate shaft bearing — replacement

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet