Note: Apply oil to all parts when assembling.
1. Using a special tool, press out the tapered roller bearing from the transfer case driven gear shaft.
1. TRANSFER CASE DRIVE GEAR SHAFT
2. PRESS
3. WASHER
4. TAPERED ROLLER BEARING
5. PIPE DISPLAYER, 0-4.5 inches (commercially available)
2. Install a 35mm thrust washer onto the transfer case driven gear shaft.
3. Using the special tool, press a new tapered roller bearing onto the transfer case driven gear shaft as shown in the figure.
Note: Use the old transfer case spacer to install the bearing, then discard it.
1. PRESS
2. MANDEL, int. diameter 40 mm, 07746-0030100
3. OLD TRANSFER CASE SPACER
4. TRANSFER CASE DRIVE GEAR SHAFT
5. TAPERED ROLLER BEARING
[Original published on this resource «hondabook.ru»]