1. CLUTCH CASE
2. Replace
3. MOUNTING PLATE
2. Using a special tool, press out the needle bearing, then remove the oil transfer plate.
1. ADJUSTABLE BEARING PULLER, 07JAC-PH80000
2. CLUTCH CASE
3. NEEDLE BEARING
3. Install the new oil transfer plate.
4. Using the special tool, press in the needle bearing as shown in the figure.
1. CLUTCH CASE
2. MANDREL HANDLE, 07749-0010000
3. MARKET, 62x68 mm, 07746-0010500
4. NEEDLE BEARING
5. OIL DISPENSING PLATE
5. Install the mounting plate and tap the bolt heads into the groove in the mounting plate.
1. 6x1.0 mm, 12Nm (1.2 kgf/m)
2. MOUNTING PLATE