1. TRANSFER CASE CASE
2. O-RING, replace
3. DAMPING HUB
4. NEEDLE BEARING
5. TRANSFER CASE DRIVE GEAR
6. TRANSFER CASE SHAFT
7. TAPERED ROLLER BEARING OUTER RING
8. TAPERED ROLLER BEARING
9. TRANSFER CASE SHAFT BUSHING
10. THRUST WASHER, 25 mm, selected on site
11. TRANSFER CASE DRIVE GEAR (HYPOID GEAR)
12. CONICAL SPRING WASHER, replace
13. TRANSFER CASE SHAFT LOCK NUT, 22x1.25mm, left-hand thread, replace
14. TAPERED ROLLER BEARING
15. TAPERED ROLLER BEARING OUTER RING
16. THRUST WASHER, 68 mm, selected on site
17. O-RING, replace
18. TRANSFER CASE COVER A
19. COVER IN TRANSFER CASE
20. O-RING, replace
21. TRANSFER CASE DRIVE GEAR (HYPOID GEAR)
22. THRUST WASHER, 35 mm, selected on site
23. TAPERED ROLLER BEARING
24. TRANSFER CASE BUSHING, replace
25. TAPERED ROLLER BEARING OUTER RING
26. TAPERED ROLLER BEARING OUTER RING
27. TAPERED ROLLER BEARING
28. SEAL, replace
29. CONNECTING FLANGE
30. O-RING, replace
31. PROTECTIVE RING
32. CONICAL SPRING WASHER, replace
33. TRANSFER CASE DRIVE GEAR LOCK NUT, 22x1.25 mm, replace
Tightening torques
| Bolt/Nut# | Tightening torque | Size | Notes |
| 6A | 12 Nm (1.2 kgf/m) | 6x1.0 mm | |
| 8C | 24 Nm (2.4 kgf/m) | 8x1.25 mm | |
| 22L | 118 Nm (12.0 kgf/m) | 22x1.25 mm | Transfer Case Shaft Lock Nut: Left Hand Thread |
| 22N | 132-260 Nm (13.5-26.5 kgf/m) | 22x1.25 mm | Transfer case driven gear lock nut. Tightening torque: depending on full starting torque |
(The original is located on the website: www.HondaBook.ru)