Contents: Gearbox housing ⇊ Clutch housing ⇊
Gearbox housing
1. Remove the oil seal from the gearbox housing.
2. Using a special tool, press the new oil seal into the gearbox housing as shown in the figure.
Note: The oil seal must be pressed in with a tolerance of ±0.5 mm from the end surface of the gearbox housing.
Clutch housing
1. Knock the seal out of the clutch housing.
2. Using a special tool, press the new oil seal into the clutch housing as shown in the figure.
Note: The oil seal must be pressed in with a tolerance of ±0.5 mm from the end surface of the gearbox housing.
(The text can be found on the website: «HONDABOOK»)