HR-V 1 (1998-2006, petrol)

Ring gear bearing — replacement (Honda HR-V 1)

0

1. Knock out the ring gear bearing.

1. RING GEAR BEARING

1. RING GEAR BEARING
2. GEAR RING

2. Using the special tool, press in the new ring gear bearing until it touches the bottom of the ring gear as shown in the figure.

1. MANDREL HANDLE, 07749-0010000

1. MANDREL HANDLE, 07749-0010000
2. MARKET, 32x35 mm, 07746-0010100
3. GEAR RING

(Publication reprinted from the website «hondabook.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Automatic gearbox

Next ▶

Flywheel housing bearings — replacement
Gearbox housing bearings — replacement
Flywheel housing input shaft seal — replacement
Differential — checking and replacing elements
Differential — design description

Control shaft assembly — removal and installation
Transfer case — design description
Replacing the transfer case drive gear bearing
Replacing the Transfer Case Driven Gear Bearing
Replacing the roller bearing of the transfer case housing

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This website uses cookies to ensure proper functioning. By clicking "OK," you agree.