Replacing the transfer case drive gear bearing (Honda HR-V 1)

Note: Apply transmission fluid to all parts during assembly.

1. Using a special tool, press out the tapered roller bearing from the transfer case drive gear.

1. MANDREL HANDLE, 07749-0010000
2. PRESS
3. MARKET, 37 x 40 mm, 07746-0010200
4. TRANSFER CASE DRIVE GEAR
5. BEARING SEPARATOR (available for sale)
6. TAPERED ROLLER BEARING

2. Using the special tool, press the new tapered roller bearing into the transfer case pinion gear.

1. MANDREL HANDLE, 07749-0010000
2. PRESS
3. SPECIAL TOOL, eg 07947-SD90200
4. TRANSFER CASE DRIVE GEAR
5. TAPERED ROLLER BEARING
6. CENTERING MANDREL FOR INNER RING, 07LAD-PW50601

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Automatic gearbox

Next ▶

Transfer case — design description
Control shaft assembly — removal and installation
Ring gear bearing — replacement
Flywheel housing bearings — replacement
Gearbox housing bearings — replacement

Replacing the Transfer Case Driven Gear Bearing
Replacing the roller bearing of the transfer case housing
Replacing the outer bearing ring of the transfer case cover A
Replacing the outer ring of the transfer case bearing
Transfer case assembly